Update 10-31-2020: I posted it here as an UNTESTED work in progress.
https://www.thingiverse.com/thing:4640040
Once again I spent way too much time on a remix which should have taken a couple hours... but I wanted to get the offset for the inductive probe closer to the nozzle. I tried side mounting it and was still off by 56mm to the left, and then tried a fan mount which looks like it could work. I'm also going to use the heatfixer (need to slightly remix that for my microswiss hot end). If the probe is too much of an obstruction to the airflow I may put a 40x20mm fan on there. The sound is not an issue since it's enclosed anyway. I just need to print this now, which will take about 15 hours, then test it out.
Update 10-31-2020: I posted it here as an UNTESTED work in progress. https://www.thingiverse.com/thing:4640040
0 Comments
Leave a Reply. |
Stoopid Me
My mission is to lower the collective IQ of teh Internets one post at a time. Archives
January 2021
Categories |