There are a few updates I'm working on, which should be posted soon (aiming for this week). The first are some additional labels for the Bambu Spares case, along with an revised SD card holder. The SD card holder on the current case is just a slot and works fine, since really it is just a slot which took several revisions to get just right. The newer design is already used on the A1 Spares Case and has a bit of a spring to help retain the cards. I need to test how the new design works on the larger X1/P1 case though, since the SD sits a bit deeper in the slots on that case.
I'm also working on some new single compartment bins, which were requested. These will use the small tabbed lids, and I decided to make them in 1x2, 1x3 and 1x4 sizes, and in 3U, 6U and 9U depths (from the Gridfinity standard).
The Ikea Alex 57.8mm base "Bigfinity" system is also almost ready to be uploaded. It's done and tested, I just need to write it up.
I have a few other things in progress, which I plan to post about when they are closer to being ready.
Finally, I'm also considering the possibility of setting up a Printables Club for anyone who wants to support my work, but also to set up a method for commercial licensing of some of my models. I'm still on the fence though, and gathering info and experiences from folks who have went down the same path. I don't want to have all the fun sucked out of this hobby, due to the expectations that may arise from commercial use licenses. Currently the only way to sell some of my designs is to violate the license, which is non-commercial on all of my designs, and most of the stuff I remix as well. That puts legitimate sellers who want to do the right thing in the position of being unable to sell prints of my designs, while many others just copy with impunity. I also get nothing for my work when that happens. But like I said, I'm on the fence about the whole thing, and trying to decide if monetizing some of my designs is worth it or not.
I'm also working on some new single compartment bins, which were requested. These will use the small tabbed lids, and I decided to make them in 1x2, 1x3 and 1x4 sizes, and in 3U, 6U and 9U depths (from the Gridfinity standard).
The Ikea Alex 57.8mm base "Bigfinity" system is also almost ready to be uploaded. It's done and tested, I just need to write it up.
I have a few other things in progress, which I plan to post about when they are closer to being ready.
Finally, I'm also considering the possibility of setting up a Printables Club for anyone who wants to support my work, but also to set up a method for commercial licensing of some of my models. I'm still on the fence though, and gathering info and experiences from folks who have went down the same path. I don't want to have all the fun sucked out of this hobby, due to the expectations that may arise from commercial use licenses. Currently the only way to sell some of my designs is to violate the license, which is non-commercial on all of my designs, and most of the stuff I remix as well. That puts legitimate sellers who want to do the right thing in the position of being unable to sell prints of my designs, while many others just copy with impunity. I also get nothing for my work when that happens. But like I said, I'm on the fence about the whole thing, and trying to decide if monetizing some of my designs is worth it or not.
RSS Feed
