9 months ago, I posted a wall wart mount for the inexpensive (yet really quite good) Tapo C120 Camera. The camera in that outdoor mount has been running since then outside, with no issues so far. It has seen ran and frost, but no ice or snow. But I had another look at the design recently, and decided to make a small change to improve the assembly process for the mount. The update will change the design of the retaining rings, which in the first version use a cross bar as a means to turning them to tighten. That bar however gets in the way of the USB cable, so I removed it, and instead added some slots for a tool that will be included. The update is fully backwards compatible. I'm running a test print now, and once it is done, it will, be updated.
I will update it first on Makerworld soon. I tried updating it on Printables, but it seems there is some problem there with uploading images, so I may circle back to update there later.
Update, the new v1.1 models are posted (and tested):
https://makerworld.com/en/models/722213-tapo-c120-camera-wall-wart-mount-v1-1#profileId-653148
https://www.printables.com/model/1047621-tapo-c120-camera-wall-wart-mount-v11
I will update it first on Makerworld soon. I tried updating it on Printables, but it seems there is some problem there with uploading images, so I may circle back to update there later.
Update, the new v1.1 models are posted (and tested):
https://makerworld.com/en/models/722213-tapo-c120-camera-wall-wart-mount-v1-1#profileId-653148
https://www.printables.com/model/1047621-tapo-c120-camera-wall-wart-mount-v11
RSS Feed
