Since the X2D was announced, I've been planning to get my H2 and P2S Spares Case updated to suppot it as well. I finally had the time to test print another case, and it looks good. I don't own the X2D, however most of it's spares, aside from the cutters, are the same as the P2S so adapting things was easy. Aside from a label, the only change from the P2S spares case parts, was to swap the small module for the base with one that has a compartment for holding the cutters (which are unique for the X2D). So the X2D version will not have a specific location for storing cutters, but they will fit in any of the compartments.
I also added a couple small lidded bins with latches, which were designed to hold spare snap in hotend labels for the cases. They could be used for other small parts as well.
You can find the updated spares case for the H2 Series, P2S and now X2D at the link below:
https://makerworld.com/en/models/2435448-bambu-h2-series-x2d-and-p2s-accessory-case-v2-0#profileId-2671977
I also added a couple small lidded bins with latches, which were designed to hold spare snap in hotend labels for the cases. They could be used for other small parts as well.
You can find the updated spares case for the H2 Series, P2S and now X2D at the link below:
https://makerworld.com/en/models/2435448-bambu-h2-series-x2d-and-p2s-accessory-case-v2-0#profileId-2671977
RSS Feed
