Updated the H2D case and Gridfinity Bins for the New Bambu H2S 3D Printer

Since the announcement of the H2S, I wanted to get the H2D Spares Case and the H2D Gridfinity Bin Hotend Holders updated to work with the new printer.  The H2D and H2S have mostly the same spare parts from what I can tell, except for the cutters, which are the same as the X1/P1/A1 series on the new H2S (while the H2D uses a cutter with a yoke design).

The H2D spares case now has a new "H2S" label option, along with a new "small" module option which carries four cutters for the H2S.  All the prior H2D parts are still there, I just added some new ones to make it possible for the new H2S owners to use the same case by printing some alternate parts for it.

The H2D and H2S Spares Case can be found over on Makerworld at the link below:
https://makerworld.com/en/models/1331229-bambu-h2d-and-h2s-spare-parts-case-version-1-1#profileId-1369592

The H2D Gridfinity Hotend Holder 2x3 Bin was also reworked to accommodate the H2S cutters.  To do this, I just swapped in the tried and tested X1/P1/A1 cutter holder design, in place of the H2D cutter holders.  It still holds 4 cutters as well, they are just the H2S compatible cutters.  I also had to move one of the screws that holds the module into the bin, so I decided to make the H2S Gridfinity Bin a separate design.

The new H2S Gridfinity Hotend Holder 2x3 Bin can be found over on MakerWorld at the link below:
https://makerworld.com/en/models/1741020-h2s-gridfinity-spares-2x3-6u-bin