This is a remix of a prior filament pass through I made for my Rubbermaid storage containers which I use as filament dry boxes. This design is intended to act as a pass through entrance for filament on my enclosure. I still need to print and test it before it will be posted. It will require cutting a 1 3/8" hole in the top of the enclosure and is held in by 3x M3x40 screws and 3x M3 nuts.
Update 10/25/2019: - It is posted on Thingiverse here:
https://www.thingiverse.com/thing:3926297
Update 6/20/2020: Drybox version posted here.
Update 10/25/2019: - It is posted on Thingiverse here:
https://www.thingiverse.com/thing:3926297
Update 6/20/2020: Drybox version posted here.
Since I posted this, I made some minor changes and got it installed. Below are some pics of the final version which can be found at the link above (Thingiverse).
RSS Feed
