I needed to make some more battery holders for my Black and Decker 20V tools. I also have some extended batteries which will not fit the holders I already have (and could not find when I went searching for them today. But I did find RSGeek's Black and Decker 20V Batter Holder on Thinginverse which looks great, but there is no model for the extended size batteries. I decided to remix (edit, it will not be a remix see below) it to fit and what was a simple 5min task turned into a whole set of battery and charger holders for the Black and Decker 20V batteries. There are all mount and 1" peg board versions since that's what I have. I'm printing a test now and will post them when they are good to go.
Update 7/25/2020: The Battery Charger Mounting Clip is posted here.
I am printing an extended battery holder and will post that when I have it tested.
Update 7/25/2020 (#2): I had the remixed holder almost printed when I read that it will not work with the charger attached to the battery. Unfortunately I need the battery + charger to both sit in the holder, so I decided that I would need to re-design the holder and I have given up on the remix. I will make my own holder to go with the charger holder. I had to model a crude battery to get the dimensions about right and the new design is almost finalized. I will post the new design once I have it tested.
Update 7/25/2020: The Battery Charger Mounting Clip is posted here.
I am printing an extended battery holder and will post that when I have it tested.
Update 7/25/2020 (#2): I had the remixed holder almost printed when I read that it will not work with the charger attached to the battery. Unfortunately I need the battery + charger to both sit in the holder, so I decided that I would need to re-design the holder and I have given up on the remix. I will make my own holder to go with the charger holder. I had to model a crude battery to get the dimensions about right and the new design is almost finalized. I will post the new design once I have it tested.
 |  |
RSS Feed
