There were a few small things that I made for projects or just to address minor annoyances around the house. The first is a clamp to mount a 1 1/2" adapter for 2" pipe, which I had to sand the OD down by 0.2mm due to poor QC on a pool valve assembly. The part was specific for the job but I updated it so it can use a variety of SAE or metric hardware.
The next thing is just a small holder for a Westinghouse power plug remote, which I'm not even sure is still being manufactured anymore. The remote holder will hold a small remote with a width and depth of 37mmx17mm and the height has to be at least 40mm.
The last thing here is probably my favorite, it's a magnetic calendar holder clip, with an integrated pen holder. It is designed to use between 6 and 7 12x3mm neodymium magnets, and has a peg which is about 4.2mm in diameter. There are two versions, one which can mount flat to a surface (like a fridge) and the other which mounts on the top corner. I made the first version with too many damn magnets and found it was gonna be really tough to open so I removed two magnets and that is the version which is now posted on Printables.
And a quick update on the Pinecil case, it's on hold for parts. I ordered a V2 and a couple USB cables to try out and see what will fit in the case. I'm hoping a 1M cable will fit without modifying the design further. I will update when the Pinecil Battery case is posted to Printables.
The next thing is just a small holder for a Westinghouse power plug remote, which I'm not even sure is still being manufactured anymore. The remote holder will hold a small remote with a width and depth of 37mmx17mm and the height has to be at least 40mm.
The last thing here is probably my favorite, it's a magnetic calendar holder clip, with an integrated pen holder. It is designed to use between 6 and 7 12x3mm neodymium magnets, and has a peg which is about 4.2mm in diameter. There are two versions, one which can mount flat to a surface (like a fridge) and the other which mounts on the top corner. I made the first version with too many damn magnets and found it was gonna be really tough to open so I removed two magnets and that is the version which is now posted on Printables.
And a quick update on the Pinecil case, it's on hold for parts. I ordered a V2 and a couple USB cables to try out and see what will fit in the case. I'm hoping a 1M cable will fit without modifying the design further. I will update when the Pinecil Battery case is posted to Printables.
RSS Feed
