CR10S Pro Scraps Bucket Is Posted

The small debris which my printer creates was getting out of hand.  I normally dyson out my enclosure after a print to clean up the scraps, but thought a small bucket may be a simpler solution.  I designed this while working on the belted z remix, and it just sticks on the side of the CR10S Pro using five 12x3 cylinder magnets, and it prints without supports.  The magnets are held in using some superglue (I use Gorilla Superglue Gel) and I plan to glue the frame to the bucket on mine.  I made one minor change between my printed part and the model posted to printables, which is to lower the height of the bucket by 1.6mm since I found that mine was just a bit too tall (my printer uses the stock feet).  If the printer is raised or uses non-stock feet, it may be necessary to add something to the base or you can adjust the model since I will include the STEP file.  This was printed using eSun Fire Engine Red PETG and Duramic 3D Black PETG.  You can find the STL and STEP files here:

​ www.printables.com/model/284470-scraps-bucket-for-a-creality-cr10s-pro