:My CR10S Pro V1 Hydra Fan Duct Remix is almost ready to test, though I had to make some additional changes to the screw holes for the hot end fan. They will now use regular M3 locknuts instead of inserts. I'm also considering other cable management ideas that could be easier to print, but getting close.
Update - I took the cable management clip off so it can print separately. Now it should print without supports. I will update with a link to Thingiverse once I have tested it out.
Update 2 (10-31-2020): I posted it here as an UNTESTED work in progress.
https://www.thingiverse.com/thing:4640040
Update - I took the cable management clip off so it can print separately. Now it should print without supports. I will update with a link to Thingiverse once I have tested it out.
Update 2 (10-31-2020): I posted it here as an UNTESTED work in progress.
https://www.thingiverse.com/thing:4640040
RSS Feed
