Maybe A 25 Bin Gridfinity Box For Stuff? (Work in Progress)

I posted the 20 bin Box for Stuff today and also posted it to Reddit in r/FunctionalPrint, where somebody asked if there would be a 25 bin version (for 1x1x6 bins).  I initially said not at this time, but long story short, I had some time tonight, and gave it a shot.  The result is pictured above, and I'm 99% sure it's gonna work, but I can never be 100% sure until I test it.  The problem though, is that I cannot test it, since it has a footprint of 242x265mm, and that is too large for my X1C (and my CR10S Pro is on ice right now).  Still, I plan to post this up as an untested remix, so it can be tested (just not by me, since my X1C is too small to print this version).  

Please note though, the 20 bin version of the Box For Stuff is fully tested (by me) and works without issues. 

UPDATE - The larger 25 bin version is posted on Printables, but it has not been tested, so print it at your own risk (but please provide feedback on it if you do make it).

https://www.printables.com/model/719788-gridfinity-25-bin-box-for-stuff-untested-remix


Update 1/18/2024: After getting some helpful feedback and suggestions, I'm re-working this 25 bin Gridfinity box, so it will fit on an X1C bed (which will speed up printing quite a bit over most larger printers).  The design is almost ready to test, however I need to update some other minor changes to the design before it's posted.

Update 1/20/2024: The  25 bin Gridfinity box has been updated to v2.0 with the following changes:

1. Redesigned to fit on the bed of a Bambu X1C (256x256), and requires the full bed area.
2. Improved label design with more robust pins.
3. Improved handle design (which should be easier to install)

 https://www.printables.com/model/719788-gridfinity-25-bin-box-for-stuff-version-20-unteste