 |  |
This is a remix of msCreations' Towel Holder (Hook_sturdy version). It was designed to be used with 3M Command Strips, and I plan to use the large size, which will be cut down slightly for length. This design uses 2 parts, the first mounts to the wall using the Command Strips, and then the towel holder slides on to that. There is a bit of a latch near the base of the holder to keep everything secure. I also changed the "V" groove just a bit to open it up and added a slight radius to it, since most of my towels are a bit thicker.
This is being printed now, but will remain a work in progress until I have it fully printed, tested and mounted (so things may change).
You can find it here (but it's a work in progress so I would not recommend printing it until I test it and update it from WIP).
Update 1/2/2021: It is printed, tested and updated, you can still find it here.
This is being printed now, but will remain a work in progress until I have it fully printed, tested and mounted (so things may change).
You can find it here (but it's a work in progress so I would not recommend printing it until I test it and update it from WIP).
Update 1/2/2021: It is printed, tested and updated, you can still find it here.
RSS Feed
