This is something that I thought of after I made the Audio Extender, and then found a slim USB 3.0 Hub which would fit just about perfectly with it. I mounted mine, sandwiched between the desk and controller for my Uplift Desk (holes were made specifically for that), but there is no reason it could not be mounted by itself. This uses the following parts, aside from the mounting screws.
The cable boots were printed with Priline Black TPU, but I plan to add some parts that should allow the whole thing to be printed in PLA (or PETG).
You can find this thing here.
The cable boots were printed with Priline Black TPU, but I plan to add some parts that should allow the whole thing to be printed in PLA (or PETG).
You can find this thing here.
 |  |
RSS Feed
